How to calculate 3D print cost
Filament, power, wear, failures and labor, with a worked example you can reproduce by hand.
Read the guideFree 3D print cost calculator
Add filament, time, power, wear, failures and your labor. Get a clear breakdown and a suggested sell price. Runs in your browser — nothing is uploaded.
In short: A published worked example of 80 g PLA in 2.5 hours on an A1 mini at 80 W costs ₪21.26 with the site formula (suggested 50% markup price ₪31.88). 100 g PLA on an X2D over 5 hours, before labor and failures, is about ₪10.54. Israeli electricity default: ₪0.635/kWh incl. VAT from 1 July 2026. Method: How we calculate (Hebrew).
The formula is open. You can check it with a calculator. Failure is applied only to the costs you pay again when a print fails.
filament = grams × (price per kg / 1000) electricity = (watts / 1000) × hours × price per kWh wear = wear rate per hour × hours labor = (hands-on minutes / 60) × hourly rate retryable = filament + electricity + wear failure = retryable × (f / (1 − f)) cost = retryable + failure + labor sell price = cost × (1 + markup)
A worked example with a $33.00 suggested price is in the cost guide. Use the “Load worked example” button to put those same numbers into the calculator.
Short, practical pages that explain the inputs and how to turn cost into a price you can charge.
Filament, power, wear, failures and labor, with a worked example you can reproduce by hand.
Read the guideWhy the power-supply label is the wrong number, how to measure average watts, and current rate examples for the US, the EU and Israel.
Read the guideMarkup versus margin, marketplace fees, and the costs this calculator leaves out on purpose.
Read the guideExample jobs with a full cost breakdown and a link that opens the same numbers in the calculator.
Open the galleryA shekel price list that will fill from official feeds or store permission — not from scraping.
See the listAffiliate links will go here after the site owner’s Amazon Associates or AliExpress affiliate account is approved. No tracking IDs have been invented.
Disclosure placeholder: once affiliate accounts are live, this site will disclose that some links may earn a commission at no extra cost to you.
Yes. Electricity is average watts ÷ 1,000 × print hours × your price per kWh. Use average draw, not the power-supply rating.
If a fraction f of attempts fail, each good print carries filament, electricity and wear times f / (1 − f). At 20% failures that is a 25% surcharge on those lines. Hands-on finishing of a successful part is not multiplied.
No. Markup is added on top of cost (50% of 10 is 15). Margin is profit as a share of the selling price (a 50% margin on a 10 cost is 20). This tool uses markup.
No. The math runs in your browser. A share link only stores the numbers you typed in the page URL, on your device, until you send it to someone.